Table of Contents
OpenFOAM Past Workshops 2013
Solver development using the open source OpenFOAM® finite volume tool set
Pretoria: 20 to 24 May 2013
The OpenSIM initiative are pleased to announce an intermediate OpenFOAM® workshop in Pretoria from 20 to 24 May 2013:
Overview and structure
OpenFOAM® is an open source finite volume tool set which is extensively used for numerical flow modelling. The course is aimed at providing an introduction to the use of the OpenFOAM® finite volume tool set for developing customised solvers. The course consists of technical presentations in the mornings, followed by a practical workshops in the afternoons.
- Date: 20-24 May
- Time: 8:30 – 16:00
Requirements
Please bring your own laptop with Linux and OpenFoam® installed. Please note as this is not a user workshop and it is expected that attendees should be able to set up and run test cases as described in the user manual.
RSVP:
The course will be limited to 10 people. Positions will be reserved on first come first served basis.
Contact:
For more info please contact
| Adriaan Steenkamp | adriaans .AT. armscor.co.za |
| Johan Heyns | jheyns .AT. csir.co.za |
Pretoria: 2 to 5 April 2013
Short overview:
The course is aimed at providing an overview of the finite volume approach for computational fluid dynamics (CFD) and applications in the open source tool set OpenFOAM®.
The course will consist of technical presentations in the mornings, followed by a practical workshops in the afternoons.
- Date: 2 to 5 April 2013
- Time: 9:30 – 16:00
- Place: Armscor (Pretoria)
Requirements:
Own laptop with Linux and OpenFoam® installation along with basic competency.
RSVP:
The course will be limited to 10 people. Positions will be reserved on first come first served basis.
Contact:
For more info please contact
| Adriaan Steenkamp | adriaans .AT. armscor.co.za |
| Johan Heyns | jheyns .AT. csir.co.za |
