======Powervault MDSM guide====== ===== Setup and Connection:===== * Open PowerVault MDSM {{acelab:cmc1.png|500px}} * Add new array manually - specify management IP addresses of each controller (default = 192.168.129.101 & 192.128.129.102). Give the array a name (eg: NFS01) {{acelab:cmc2.png|500px}} * Once added, connect to array * Do not automatically configure array when prompted (select No) {{acelab:cmc3.png|500px}} =====Creating Disk Group:===== * Select "Storage & Copy Services" tab, then right click on "Total Unconfigured Capacity", select "Create Disk Group" * Click Next, then give the Disk Group a name (eg: NFS_GROUP_01), then select Manual (Advanced), then Next. {{acelab:cmc4.png|500px}} * Select correct RAID level from drop down (RAID 6 recommended), then select all but the last disk on left panel and add to right panel. (Last disk will be a hot spare) {{acelab:cmc5.png|500px}} * Click "Calculate Capacity", then Finish =====Creating Virtual Disk:===== * After completing last step, when prompted to create Virtual Disk, Select Yes. Otherwise right click on "Free Capacity" and select "Create Virtual Disk..." {{acelab:cmc6.png|500px}} * In the capacity field, copy the amount from the "Free Capacity" shown above. * Name the VD, (eg: NFS_VD_01). Select "Map Later" from the drop down. Make sure "I/O Characteristics" is set to File system (typical). Click Finish =====Creating Hot Spare:===== * Select "Hardware" from top bar, then "Hot Spare Coverage...", then select "View/Change current coverage" {{acelab:cmc7.png|500px}} * Click the disk group you just created on the left panel, then "Assign..." * The last disk that we did not assign to the disk drop should be available and selected, click "Ok". The Hot Spare Summary should read: "Standby: 1" =====Host Mapping===== Click on host mapping tab, right click on "Default Group" and select "Add Group". {{acelab:cmc8.png|500px}} Right click on the created group and select "Add host". {{acelab:cmc9.png|500px}} {{acelab:cmc10.png|500px}}