Differences

This shows you the differences between two versions of the page.

--- howto:coarrayfortran [2017/04/13 09:39]
ccrosby
+++ howto:coarrayfortran [2021/12/09 16:42] (current)
@@ Line 8: / Line 8: @@
 </code>
-to your scripts will set up the appropriate paths to OpenCoarrays.
+to your scripts will set up the appropriate paths to OpenCoarrays-1.8.4.
+**OpenCoarrays-2.3.1** has been installed in ''/apps/chpc/compmech/OpenCoarrays-2.3.1'' and is compiled using mpich-3.3 and gcc-8.3.0. A module has been created so simply adding:
+<code>
+module add chpc/compmech/OpenCoarrays/2.3.1
+</code>
+to your scripts will set up the appropriate paths to OpenCoarrays-2.3.1.
+**OpenCoarrays-2.9.2** has been installed in ''/apps/chpc/compmech/OpenCoarrays-2.9.2'' and is compiled using mpich-3.3 and gcc-8.3.0. A module has been created so simply adding:
+<code>
+module add chpc/compmech/OpenCoarrays/2.3.1
+</code>
+to your scripts will set up the appropriate paths to OpenCoarrays-2.3.1.
 Co-array programs are compiled using the ''caf'' wrapper, much like ''mpif90'' is used to compile MPI programs.  The compiled binary is then executed using the ''cafrun'' wrapper, similar to ''mpirun''.  ''cafrun'' in this case takes the same command line options as the ''mpirun'' wrapper supplied by mpich.  Please bear in mind that mpich will not by default use the infiniband network.  To use the infiniband network, use the following syntax:

wiki.chpc.ac.za