Differences

This shows you the differences between two versions of the page.

--- howto:fds [2022/10/05 13:32]
ccrosby
+++ howto:fds [2022/10/05 13:35] (current)
ccrosby [Postprocessing]
@@ Line 91: / Line 91: @@
 ===== Postprocessing =====
-Smokeview is also installed on the system, and can be accessed with the command ''smokeview'' or ''smv''.  However, this is only possible when using one of the visualisation nodes chpcviz1 or chpclic1.  Please read the instructions on [[howto:remote_viz|setting up a VNC connection]], and run Smokeview with the VirtualGL wrapper ''/opt/VirtualGL/bin/vglrun smokeview''.  It may also be practical to use the very well-developed visualisation codes [[howto:paraview|Paraview]] or [[howto:visit|VisIt]].  Please experiment and provide feedback.
+Smokeview is also installed on the system, and can be accessed with the command ''smokeview'' or ''smv''.  This can be done  on one of the visualisation nodes chpcviz1 or chpclic1.  Please read the instructions on [[howto:remote_viz|setting up a VNC connection]], and run Smokeview with the VirtualGL wrapper ''/opt/VirtualGL/bin/vglrun smokeview''.
+If you want to run Smokeview on a compute node, please read the instructions at https://wiki.chpc.ac.za/howto:remote_viz#getting_a_virtual_desktop_on_a_compute_node.  You will need to load a mesa module to enable software rendering.
+ It may also be practical to use the very well-developed visualisation codes [[howto:paraview|Paraview]] or [[howto:visit|VisIt]].  Please experiment and provide feedback.
 ===== Parallel Scaling =====

wiki.chpc.ac.za

User Tools

Site Tools

Differences

Page Tools